Rookie question but I cannot seem to have my wyswyg showing as it is in the back end editor into the front end.
I have placed all content in a table to hopefully have the content view as shown in the wyswyg editor view.
I sized the wyswyg to have the same height and width in all panels looking to have the Images to show on one half of the page view and the article content to the other half.
I am sure it is plain to anyone who uses JCE regularly however my first attempt so will appreciate some advice.
The images seem to fit OK with regard the size selected in the editor however the text is far larger than I would have expected from the back end view.
Also text extends past the image in the second image/text table I think because of this over sizing in the front end.
Many thanks in advance
kiwilefty1953
I have placed all content in a table to hopefully have the content view as shown in the wyswyg editor view.
I sized the wyswyg to have the same height and width in all panels looking to have the Images to show on one half of the page view and the article content to the other half.
I am sure it is plain to anyone who uses JCE regularly however my first attempt so will appreciate some advice.
The images seem to fit OK with regard the size selected in the editor however the text is far larger than I would have expected from the back end view.
Also text extends past the image in the second image/text table I think because of this over sizing in the front end.
Many thanks in advance
kiwilefty1953
It seems that module parameters haven't been configured properly. Please make sure that you are using a valid twitter username, and
that you have inserted the correct keys. Detailed instructions are written in the module settings page.